beautypg.com

Pre-installation – Lennox Hearth VIS35 User Manual

Page 6

background image

Pre-Installation

f

eatures

Installation Options

Residential

Vented vertical and horizontal

Manufactured (mobile) home

Natural gas (NG) or propane (LP)

Bedrooms

Optional wall-mounted or remote thermostat

Venting

This stove can be vented with Security™ Secure Vent™

pipe*. Coaxial pipe diameters are 6-5/8” outer and 4” inner.

The combustion air for this stove is drawn from outside the

house through the outer DV (direct vent) pipe. Room air is

not required for combustion.
When planning your installation, select the correct length of

vent pipe for your particular requirements. Determine the

minimum clearance to combustibles from the rear of the

unit to the wall. It is also important to note the thickness

of the wall. Before cutting the vent hole through the wall

make sure that ALL vent and termination clearances (see

page 16) will be met.
Electrical

The standard fan motor requires 120 Volts AC for operation.

The stove is not dependent on the fan or an outside electri-

cal supply to operate.

WARNING - Electrical Grounding

Instructions - This appliance is equipped with a three-

prong (grounding) plug for your protection against shock

hazard and should be plugged directly into a properly

grounded three-prong receptacle. Do not cut or remove

the grounding prong from this plug.

Millivolt Valve

This stove is operated with a millivolt valve and therefore

burns even during a power outage.

Fuel

This stove comes from the factory equipped to burn natural

gas at a specified elevation. The stove can be converted to

burn LP gas (liquid propane) by changing the cassette (valve

and pilot assembly) or installing a conversion kit. Only Lennox

Hearth Products conversion kits can be used to convert from

NG to LP or LP to NG. Contact your Lennox Hearth Products

dealer for details.

Specifications

Stove weight: 150 lbs

Pipe:Type - direct-vent

Recommended manufacturer*

Security™ Secure Vent™*

Diameter - 6-5/8”x 4” for all installations

Stove Packaging List

The

Vintage™ gas stove comes with the following parts:

1 Stove Body with Burner Cassette

1 Log Set

1 Bag of Ember Material

1 Installation and Operation Manual

Optional Parts

150 CFM Blower

Reversible Cast-Iron Panels

Stone Panel Inserts - Autumn, Savoy and Verde

* Other approved chimney brand is Simpson Dura-Vent DV-GS.

RATINGS

Vintage™ (VIN)

NATURAL GAS

LP GAS

Max/Min Input BTUh 0-,000 Feet

(0-10 M)

u

27,000 / 19,500

27,000 / 21,300

O

rifice (DMS) 0-,000 Feet (0-10 M)

u

#36/.106 IN.

#52/.064 IN.

Manifold Pressure (IN. WC)

3.5 / 1.8

10.0 / 6.0

Min. Inlet Pressure (IN. WC)

5.0

11.0

Maximum heat output BTUs/hour-steady state

,140

,140

P4 Efficiency

w

47.00%

49.07%

Orifice (DMS) 0-,000 Feet (0-10 M)

u

#40/.098 IN.

#53/.060 IN.

u

Unit factory equipped for 0-000 FT/0-10 M, In Canada 0-4500 FT/0-170 M

v

The Steady State Efficiency numbers based on maximum vent configuration.

w

Tested to CSA P.4.1-0 “Testing Method for Measuring Annual Fireplace Efficiency.

Electrical Rating: 10 VAC, 0 HZ, Less Than Amps

This manual is related to the following products: