Linksys 10/100 - Manual (Page 33)

EtherFast 10/100 PrintServers
IPX Setup for Windows NT 4.0
1. Click on Start, Settings, and Control Panel. Double-click on the
Network icon.
2. When the Network window appears, click on the Protocols tab. Click on
the Add button.
3. Find the IPX/SPX protocol in the Select Network Protocol field. Click
on it once, then click OK.
61
Instant EtherFast ® Series
TCP/IP Setup for Windows NT 4.0
1. Click on Start, Settings, and Control Panel. Double-click on the
Network icon.
2. When the Network window appears, click on the Protocols tab. Click on
the Add button.
3. Find the TCP/IP protocol in the Select Network Protocol field. Click on
it once, then click OK.
4. When asked if you want to use DHCP, click on No.
5. If asked to supply your Windows NT CD, do so. NT will copy the neces-
sary files to your system. You may have to switch between your
PrintServer Setup CD and the NT CD.
6. When TCP/IP appears in the Network Protocols window, click on the
Bindings tab. Windows will store your new bindings.
7. Click on the Protocols tab. Click once on TCP/IP.
8. Click on the Properties button. Select the type of network adapter you
have from the Adapters box. Click on Specify an IP Address.
9. Enter the IP Address for the computer, along with the Subnet Mask.
Check with your network administrator for your settings.
10. Enter your Default Gateway if you have one; otherwise, leave the entry
blank.
11. When you finish, click OK. If NT asks about WINS, ignore it.
12. When the Network window reappears, click Close. Restart your comput-
er when prompted. TCP/IP has now been successfully installed.
N No otte e:: a Default Gateway is not required. Check with your network administrator.
60