Lancom Systems LCOS 3.50 - Manual (Page 33)

̈ Chapter 3: Configuration and management LANCOM Reference Manual LCOS 3.50
33
Configu
rat
ion
a
n
d
ma
na
ge-
men
t
̈ Status
Contains all read-only statistics of the individual SW modules
̈ Setup
Contains all configurable parameters of all SW modules of the device
̈ Firmware
Contains all firmware-management relevant actions and tables
̈ Other
Contains dialling, boot, reset and upload actions
3.8.1 Command line reference
Navigating the command line can be accomplished by DOS and UNIX style
commands as follows:
Command Description
cd Change the current directory. Certain abbreviations exists,
e.g. ”cd ../..” can be abbreviated to ”cd ...” etc.
del
rm Delete the table entry with the index
dir []
list[]
ls []
ll [] Display the contents of a directory
do [] Execute the action in the current directory.
Parameters can be specified
exit/quit/x Close the console session
feature Unlock the feature with the specified feature code
passwd change password
ping [IP address] Issues an ICMP echo request to the specified IP address
readconfig Displays the complete configuration of the device in
”readconfig” syntax
readmib display SNMP Management Information Base
repeat repeats command every VALUE seconds until terminated
by new input
stop stop ping
set Set a configuration item to the specified value. If the item
is a table entry, multiple values must be given (one for
each table column). A ”*” as a value indicates that the
column in question should be left at its previous value.