Crossover cable – Lucent Technologies Network Access Module User Manual
Page 59
B-3
Crossover Cable
Crossover Cable
This RJ-45 crossover cable is used to connect two (and only two) machines using
10baseT Ethernet without the use of a hub. The cable must be fabricated from category
5 unshielded twisted pair. Table B-4 shows the wiring for this cable.
Table B-4
Crossover Cable Wiring
RJ-45 Connector
RJ-45 Connector
pin 1
pin 3
pin 2
pin 6
pin 3
pin 1
pin 6
pin 2
See also other documents in the category Lucent Technologies Hardware:
- 9076 (150 pages)
- CELLPIPE 7820-0766-004 (48 pages)
- AnyMedia Line Access Gateway (4 pages)
- CellPipe 22A Series (2 pages)
- Stinger MS+DSL (2 pages)
- ATM Module 8-Port DS3/E3 (2 pages)
- Web Services Gateway OmniAccess 8550 (8 pages)
- 7820-0657-001 (34 pages)
- Alcatel-Lucent VPN 1200 (6 pages)
- Stinger STGRSACR-SO-ADSL2P (2 pages)
- 106433691 (7 pages)
- 2000 (2 pages)
- VPN Firewall Brick 20 (4 pages)
- 20A-USB (2 pages)
- GW-DS300N (78 pages)
- Wavelength Extension Solution Metropolis (4 pages)
- Lucent Network Gateway (2 pages)
- 20H (2 pages)
- 5800 Series (88 pages)
- Cajun Switch P550R (41 pages)
- PortMaster (364 pages)
- 2300 (2 pages)
- Multiplexer and Transport System ADM 16/1 (8 pages)
- Cajun M770 (72 pages)
- DSL Element Management System NavisAccess (4 pages)
- Ethereal (199 pages)
- 3000 (586 pages)
- CellPipe 55 Series (2 pages)
- Telephone User Interface Serenade (2 pages)
- APX 1000 (4 pages)
- PacketStar PSAX (4 pages)
- DSL Access Concentrator Stinger FS+ (4 pages)
- USS-720 (96 pages)
- AnyMedia 4300 (2 pages)
- CellPipe 40H-CES (2 pages)
- Stinger Trunk Module OC-12/STM-4 (2 pages)
- Host-Based Controller Modem AT (87 pages)