Lucent Technologies Network Access Module - Manual (Page 21)

2-1
Getting Ready for Configuration 2
To properly configure your INA module, you must gather all the technical information
needed. You must also assign T1/PRI channels using the MERLIN MAGIX administration
console before using the INA module.
Before starting the installation of your module, be sure that you have all needed
information from the following categories:
• “T1/PRI Provisioning” on page 2-1
• “Network Settings” on page 2-2
T1/PRI Provisioning
Table 2-1 illustrates the T1/PRI information needed to set up the data networking
capabilities of the INA module. Make sure that you have obtained this information from
your telco provider before beginning the configuration process. See Appendix C,
“MERLIN MAGIX Administration” for more information.
Table 2-1 Basic T1/PRI Provisioning Information.
Set Up T1/PRI on the MERLIN MAGIX
Table 2-1 lists only the T1/PRI settings that are related to the data networking
capabilities of the INA module. Additional settings are required to fully configure the
INA module to support voice services. Examples include B channel group assignments
Setting Notes Example
DSU channel selection DSU Channel Selection is
used to assign data
channels to the INA
module. The number of
channels can range from
1 to 24. Channel 20, 21, 22, 23
Suppression Bipolar 8-zero
substitution (B8ZS) zero
code suppression must
be used in all applications
of the INA module. For
PRI configurations, only
B8ZS zero code
suppression is supported. B8ZS
Activate or Deactivate
the CSU The INA module supports
an internal CSU. Activate