Lexmark 2400 - Manual (Page 15)

15
Top-Of-Form
Setting Top-Of-Form for continuous form paper
in push mode
Top-Of-Form can range from minus 1 inch to plus 14 inches from the top of
continuous form paper.
Note: Use this method to also set Top-Of-Form for continuous
forms loaded in the optional Tractor 2 Feeder.
1 Clear the paper path.
If the Paper Out light is Off, tear off excess forms and press Load/Unload.
Press FormFeed to clear a cut sheet.
2 Move the paper select lever to continuous forms .
3 Load continuous form paper on the push tractor feed pins (or Tractor 2
feed pins if you are using the optional Tractor 2 Feeder).
4 Remove the ribbon access cover.
5 Press Load/Unload. The Paper Out light goes Off.