Life Fitness otal Body Trainer 95Xe T - Manual (Page 9)

1.3 S
ETUP
Read the Operation Manual before setting up the Total Body Trainer.
E
LECTRICAL
P
OWER
R
EQUIREMENTS
The Total Body Trainer requires an AC power supply according to the electrical configurations
listed in the chart below.
NOTE: Do not modify the plug provided with this product. If the plug does not fit into an available
electrical outlet, have a proper outlet installed by a qualified electrician.
W
HERE TO
P
LACE THE
T
OTAL
B
ODY
T
RAINER
Following all safety instructions in Section 1.1, move the Total Body Trainer to the location in
which it will be used. See Section 7, titled Specifications, for the footprint (product dimensions).
Allow one foot of clearance in front of the Total Body Trainer to allow for movement of the pedal
levers. It should be easy to mount the Total Body Trainer from the side.
H
OW TO
S
TABILIZE THE
T
OTAL
B
ODY
T
RAINER
After placing the Total Body Trainer in position, check the unit’s stability by attempting to rock it. Any
slight rocking indicates that the unit must be leveled. Check the front stabilizing feet to determine
which foot does not rest fully on the floor. Rotate the foot counter-clockwise to lower it. Recheck the
stability and adjust again as needed until the Total Body Trainer is stable and no longer rocks. Lock
the adjustment into position by tightening the jam nut against the stabilizer bar with an open
end 17mm wrench.
.
8
Supply Voltage
(VAC)
100
110
120
200
220
230
240
Frequency
(Hz)
50 / 60
50 / 60
50 / 60
50 / 60
50 / 60
50 / 60
50 / 60
Rated Current
(Amps)
1.6
1.6
1.6
.8
.8
.8
.8