Land Pride RC5515 User Manual
Page 46
44
Section 5: Maintenance & Lubrication
RC5515 & RC6515 (540 RPM) RCM5515 & RCM6515 (1000 RPM) Rotary Cutter 318-721M
5/29/13
CV Main Driveline Joints & Shields
CV = Constant Velocity
Type of Lubrication: Multi-purpose Grease
For instructions on how to access grease zerks shown
in Figure 5-13, see “Accessing CV Driveline Joints”
on page 45.
•
The constant velocity joint should be greased in a
straight position forcing grease through the passages
and into the cavity. After lubrication, grease should
be visible around the ball joints.
•
Grease fittings located on the u-joints and driveline
shields should be lubricated every 8 hours of
operation.
IMPORTANT: To extend the life of the constant
velocity joint, extensive lubrication must be
performed every 8 hours of operation.
8
Hours
CV Main Driveline Profile Tubes
CV = Constant Velocity
Type of Lubrication: Multi-purpose Grease
Quantity = Coat Generously
IMPORTANT: To extend the life of the constant
velocity joint, the grease zerk for the profile tubes
must be lubricated every 8 hours.
20
Hours
Drivelines with external grease point for Profile Tube
Drivelines with internal grease point for Profile Tube
CV Driveline with external grease point for Profile Tube
Figure 5-13
CV Driveline with internal grease point for Profile Tube
Figure 5-14
23556
8-10 pumps
Zerk Located through slot in tube
23565
Zerk Located on end of tube
23556
4-5 pumps
2-3 pumps
2-3 pumps
4-6 pumps
23565
Access Zerk through hole in shield