LOREX Technology LW2301 - Manual (Page 26)

Recording
22
Manual Recording
Manual Recording allows you to manually start/stop recording from one channel at a time . You
cannot record while in Quad mode.
You can also record while in Zoom mode. For details on using Zoom, see “Zoom” on page 43.
NOTE: You cannot change channels or enable Auto Sequence Viewing Mode during Manual
Recording.
To enable Manual Recording:
1. Select a channel (1~4) on the wireless receiver or from the remote control.
2. Press the Record— button on the remote control or RECORD—M button on the wireless
receiver. A blue LED will light up under RECORD—M on the wireless receiver.
3. To stop Manual Recording, press the Record— button on the remote control or
RECORD—M button on the wireless receiver again.
When Should I Use Manual Recording?
• Emergency recording
• Low traffic environments
Figure 7.0 Recording indicated by the OSD
C C a a m m 1 1 R R E E C C
160602-1.AVI
2009 07 17
16:32:05