Land Pride RCM6015 - Manual (Page 32)

30
Section 5: Maintenance & Lubrication
RC5015 & RC6015 (540 RPM) and RCM5015 & RCM6015 (1000 RPM) Rotary Cutters 318-047M 8/28/08
Land Pride
Table of Contents
Storage
It is good practice to clean, inspect, service and make
necessary repairs to the cutter when parking it for long
periods and when parking it at the end of a working
season. This will help ensure the cuter is ready for field
use the next time you hook-up to it.
!
DANGER!
Always disconnect main driveline from tractor PTO and secure
cutter deck in the up position with solid supports before
servicing the underside of the cutter.
1. Clean off any dirt and grease that may have
accumulated on the cutter and moving parts. Scrape
off compacted dirt from the bottom of deck and then
wash surface thoroughly with a garden hose. A
coating of oil may also be applied to the lower deck
area to minimize oxidation.
2. Check blades and blade bolts for wear and replace if
necessary. See “Cutter Blade Maintenance” on
page 24.
3. Inspect for loose, damaged or worn parts and adjust
or replace as needed.
4. Lubricate as noted in “Lubrication Points” starting on
page 31.
5. Replace all damaged or missing decals.
6. Store cutter on a level surface in a clean, dry place.
Inside storage will reduce maintenance and make for
a longer cutter life.
7. Follow all unhooking instructions on page 17 when
disconnecting tractor from cutter.
8. Repaint parts where paint is worn or scratched to
prevent rust. Ask your dealer for Aerosol Land Pride
touch-up paint. They are also available in touch-up
bottles with brush, quarts and gallon sizes by adding
TU, QT or GL to the end of the Aerosol part number.
Land Pride Touch-up Paint
Part No. Part Description
821-011C PAINT LP BEIGE SPRAY CAN
821-002C PAINT LP BLACK SPRAY CAN
821-054C PAINT MEDIUM RED SPRAY CAN
821-058C PAINT GREEN SPRAY CAN