Lantronix UBox UBX4100 - Manual (Page 56)

Troubleshooting
Rebooting the UBox into Safe Mode Using the Reset Button
If you have made an unwanted change to the UBox settings and can no longer
access the UBox, you can boot it into a “safe mode.” In this mode, the UBox reboots
using default settings (e.g., multi-user connect mode or default IP mode) and allows
you to view and edit the settings.
To boot into safe mode:
1. Press and hold the reset button until the lights turn off (this takes 3 or more
seconds). It takes approximately 15 seconds to complete the reset.
2. In the Lantronix UBox application, make sure that your Local UDP Port is set to
10010.
3. Once you have verified the port, check the Lantronix UBox application to see
whether your UBox displays.
4. If it does not display, check the SYSTEM status LEDs to determine the UBox’s
network condition.
Troubleshooting: USB Devices
To troubleshoot problems with USB Devices:
1. Open the Lantronix UBox application. You should see your USB device listed.
Make sure Show All Devices displays in the list box below the tabs.
2. If your USB device does not display:
a) Check the USB LED status.
b) Connect the device directly to the PC to verify that the device is functioning.
To troubleshoot issues with multiple users of a USB device:
If … Suggestions
You are sure that no one
else is using your USB
device, and the device still
shows up as In Use Contact Lantronix Technical Support.
Your USB device displays
and is Connected. You should be able to use the USB device as you would
normally.
‹ If your USB device is a printer, you should be able to
print by going to your File menu and selecting Print.
‹ If your USB device is a scanner, you should be able
to open the scanner software and use your scanner.
You are not able to use
your device Refer to your USB device’s troubleshooting instructions for
what to do next.
If you are still not able to use your USB device, please contact
Lantronix Technical Support.
UBox User Guide 56