Lexmark OptraImage 232 User Manual
Page 29
OptraImage Setup Guide
29
Replacing the ADF
pad assembly
If you experience problems with papers double-feeding
through the ADF, the pad assembly may be worn out and
need to be replaced.
1
Turn off the scan unit and disconnect the power supply.
2
Open the ADF front cover
.
3
Remove the old ADF detachable pad assembly by
squeezing and pulling out the upper part of the pad clamp
4
Hold the upper part of the new clamp, squeeze, and place
it gently in the pad holder.
5
Close the ADF.
6
Reconnect the power supply and turn the scan unit back
on.
This manual is related to the following products:
See also other documents in the category Lexmark Printers:
- E260d (142 pages)
- 6600 Series (173 pages)
- 10N0227 (1 page)
- Z12 (2 pages)
- 301 (144 pages)
- NO. 35 (1 page)
- Z65n (111 pages)
- dn2 (217 pages)
- 10E (144 pages)
- Z2300 (54 pages)
- 230 (213 pages)
- 310 Series (2 pages)
- PRO700 (24 pages)
- C 720 (18 pages)
- C520 (145 pages)
- X656 MFP (104 pages)
- Prospect Pro207 (27 pages)
- 337 (258 pages)
- T64x (6 pages)
- C524 (146 pages)
- 4098-001 (70 pages)
- 1200 Series (21 pages)
- X650 Series (8 pages)
- 5300 (179 pages)
- 302 (274 pages)
- 4549 (235 pages)
- 202 (320 pages)
- 4076-0XX (89 pages)
- 10N0016 (1 page)
- 5025 (171 pages)
- 1361760 (1 page)
- C 546dtn (6 pages)
- Interpret S400 (40 pages)
- x6575 (2 pages)
- 27S2156-001 (2 pages)
- MENUS AND MESSAGES C522 (55 pages)
- Z35 (101 pages)
- Z25 (24 pages)
- series x5100 (77 pages)
- Z82 (105 pages)
- 2500 Series (76 pages)
- 1200 (208 pages)
- Z33 (114 pages)
- 7600 Series (181 pages)