Little Wonder Xtra - Manual (Page 16)

PROBLEM CAUSE ACTION
Engine will not run. Ignition switch is “OFF”
Empty fuel tank
Primer bulb was not pushed enough times
Engine is flooded
Turn switch “ON.” Push down.
Fill fuel tank.
Press primer bulb fully and slowly
5 times.
Use starting procedure without
using choke. See page 11.
Engine runs rough
or is hard to start. Carburetor/crankcase/cylinder
gaskets/crankshaft seal leaking
Damaged engine parts
Tighten screws.
Replace gaskets with a sealant and
tighten screws. Replace crankshaft
seal, damaged parts.
Engine lacks power
or stalls when cutting. Dirty air filter
Blocked muffler Clean or replace air filter.
Clean muffler
Cutting blade
does not turn
when operating. Blade cover filled with dirt/grass.
Clutch slipping.
Loose blade nut. Clean.
Cut less depth. Check clutch.
Tighten nut. See page 14.
Gear case leaking. Loose screws
Broken “O” ring Tighten.
Replace.
Noisy gears. No heavy oil in gear case.
Loose blade nut or gear adjustment
incorrect. Refill. See page 14.
Reassemble parts correctly.
T
ROUBLESHOOTING
T
IPS
16