Kawai CN4 User Manual

Page 51

JACKS

Jacks

OTES

ABOUT

USB

The CN piano can be connected with a personal computer with a USB cable for exchanging MIDI data. You
need a USB driver installed in your computer.

[For Windows XP/Me users]
A standard USB driver is already installed in your computer. You don’t need to install a new driver.

[For Windows 2000/98SE users]
You need to install the designated driver in your computer. Visit the KAWAI web site at http://www.kawai.co.jp/
english/Download1.html and download the program.

[For Macintosh users]
Macintosh OSX automatically recognizes our USB interface. No special driver is needed. Older Macintosh
OS are not supported by us. If you have an older Macintosh OS, please use an appropriate MIDI interface and
MIDI cables when connecting the CN piano to a Macintosh computer.

NOTE:
When both MIDI jacks and USB jack are connected, USB has priority.
When connecting USB cable to the CN piano, first connect the USB cable and then turn the power of the CN
piano on.
It may take some time to start communication when the CN piano is connected to the computer via USB.
When USB communication is unstable with connection via hub, connect the USB cable directly to the USB
port of the computer.
Turning the power of CN piano on/off or disconnecting the USB cable while the following actions may cause
unstable communication.

while installing USB driver
while booting up the computer
while MIDI application is working
while communicating with the computer
while the computer is in energy saver mode

* If you have any problem with USB communication, consult the instruction manual of your computer and
check your computer set up.

* The USB-MIDI conversion board TID10000934 used in the CN piano is approved to show the USB logo.
The USB logo can be used only for the product which is approved by USB-IF (USB Implements Forum Inc.)
test.

* Windows is registered trademark of Microsoft Corporation.

* Macintosh is registered trademark of Apple Computer, Inc.