Kenwood DPX502 User Manual
Page 29
English
|
29
Other than Standby mode
Audio Preset Recall
Recalling the sound setup registered by
1
Select the source
Press the [SRC] button.
2
Enter Menu mode
Press the [MENU] button for at least 1 second.
"MENU" is displayed.
3
Select Audio Preset mode
Push the Control knob towards up or down.
Select the "A-PRESET" display.
4
Enter Audio Preset mode
Press the Control knob for at least 1 second.
5
Select the Audio Preset Recall
Push the Control knob towards up or down.
Select the "RECALL" display.
6
Recall the Audio Preset
Press the Control knob for at least 2 seconds.
The "RECALL" display blinks 1 time.
7
Exit Audio Preset mode
Press the [MENU] button.
⁄
• The User memory of
the value which was recalled.
• The source tone memory item of
8) is changed to the value which was recalled by the
selected source.
In Standby mode
Firmware version display
Displaying the firmware version with the unit.
1
Select the firmware version display mode
Push the Control knob towards up or down.
Select the "F/W VER" display.
2
Display the firmware version
Push the Control knob towards right or left.
In Standby mode
Demonstration mode Setting
Sets the demonstration mode.
1
Select the Demonstration mode
Push the Control knob towards up or down.
Select the "DEMO" display.
2
Set the Demonstration mode
Press the Control knob for at least 2 seconds.
Each time you press the knob at least 2 seconds,
the Demonstration mode alternates between the
settings shown in the table below.
Display
Setting
"DEMO ON"
The Demonstration mode function is ON.
"DEMO OFF"
Exit Demonstration mode (Normal mode).