beautypg.com

Switching between disc changers, How to switch to aux sound, English – Kenwood KCA-S210A User Manual

Page 6: Unit group a, Unit groups b/c/d, If the unit you are connecting belongs to group a

background image

6-

English

Switching between disc changers

Unit group A

Select the disc changer to be controlled with the
controller2. When the disc changer mode is
selected with the source button, playing begins.

• You cannot change the disc-changer number while a disc changer is playing. To change the disc changer

number, press the source button to stop playing, then change the disc changer number with the
controller2. Select the disc changer mode with the source button.

• When the disc changer number is changed and play begins, the disc changer number data before it was

switched may be shown temporarily on the display of the centre unit.

Unit groups B/C/D

Each time the SRC button (or CH button) on the centre unit is
pressed, the disc auto changer mode changes between disc
changer modes 1 and 2. When the desired disc changer
number is selected, playing starts.

How to switch to AUX sound

If the unit you are connecting belongs to group A

2CAUTION

CHANGER

12

Disc changer 1

Disc changer 2

Y

ou can switch between

disc changers 1 and 2 by
the switching unit.

2

EJECT

TAPE

CD MD

PWR OFF

3

1

CHANGER

1

2

• If you are going to connect only one disc changer, connect it to the TO CHANGER 2 terminal on the

switching unit.

• If you are going to connect only the AUX terminal of the switching unit, you do not need to connect a

controller.

• After selecting on the centre unit, you will not be able to switch to AUX sound, even if

you operate the switching unit or the controller switch.

If you want to listen to the sound from the unit connected to the terminal TO CHANGER 1 or 2 on the
switching unit, first either turn off the power to the centre unit, or switch to another source, then turn the
AUX switch to “OFF”. Next, turn the controller switch to “1” or “2”, and select .

NOTE

2CAUTION

Turn the centre unit power off, or select another source, then
set the AUX switch on the switching unit to “ON”.

Set the controller switch to “1”

If you have only connected the AUX terminal, you will not
need to carry out any further operations.

Select on the centre unit.
The sound input to the AUX terminal will now be output.

The centre unit display will stay in the following state:

Disc No.=1, Track No.=1, Playing time = 0 min 0 sec

NOTE

Controller2

R

L

AUX

I

AUX

SWITCH

OFF

ON

PROTOCOL

SWITCH

O

N

or

AUTO

AUTO