Kenwood TS-480SAT - Manual (Page 88)

80
14 CONNECTING PERIPHERAL EQUIPMENT
SKY COMMAND II (K-TYPE ONLY)
■ TM-D700A
In order to connect the TS-480 transceiver to the
TM-D700A transceiver, you need to prepare
3 cables by yourself. For the connection between
the COM connectors on the 2 transceivers, you
may use a commercially available RS-232C cross-
wired cable.
Note:
◆ Switch OFF both the TM-D700 and TS-480 transceiver before
making the connection.
◆ The TM-D700A transceiver automatically transmits its call sign
in Morse code at regular intervals because of legal
requirements; therefore, transmit sidetone must be output
from the TS-480 transceiver.
◆ When the TM-D700A transceiver is too close to the TS-480
transceiver, unwanted feedback may cause malfunction.
◆ Do not share a regulated power supply between the
TM-D700A transceiver and the TS-480 transceiver. Unwanted
feedback may cause malfunction.
COM
connector
COM
connector
3.5 mm (1/8 ")
speaker jack
RJ-45
MIC jack
RJ-45
MIC jack
3.5 mm (1/8 ")
speaker jack
GND (MIC)
MIC
NC
DWN
STBY (MIC)
GND
8 V DC
UP
GND (MIC)
MIC
NC
DWN
STBY (MIC)
GND
8 V DC
UP
TM-D700A
transceiver
TS-480
transceiver