Kenwood DPX-4010 - Manual (Page 32)

— 32 —
English
Installation (for HONDA ACURA Car)
Installation type 1 ■
DPX-4010
Use Accessory1 to attach the
unit which was assembled in
Assembly.
1
Install the center panel
with the unit in your car.
The illustration shows an
example of installation
using a vehicle bracket.
The shape of the bracket
varies with the vehicle to
be installed. Some bracket
requires three screws
(Accessory1) on each
side.
NOTE
2
Accessory1
(M5
× 6 mm)
If accessories 6 and 7 hit the inside of the console, preventing
the unit from being attached tightly, snap their end parts off as
shown below.shipped with the unit, as shown above.
NOTE
Be careful not to get injured with the new edge.
2CAUTION
Accessory67
Installation type 2 ■
Accessory!
(M5
× 10 mm)
DPX-4010
Factory-installed
car stereo
Installation type 3 ■
DPX-4010
Factory-installed
car stereo
DPX-4010
Accessory9
(M3
× 6 mm)
Accessory@
Accessory!
(M5
×
10 mm)
Remove the factory-installed
car stereo and install the unit. 2
Reuse the screws
that were removed.
Attach Accessory@ to
Accessory8 which was
assembled in Assembly.
1
Remove the factory-installed
car stereo and install the unit.
2
Attach Accessory8 which
was assembled in
Assembly.
1
DPX-4010
Accessory9
(M3
× 6 mm)
Accessory8
Accessory8 is to be fixed either
to the center or bottom,
depending on the car model.
Accessory8
Accessory0
(M5
× 6 mm)
Accessory0
(M5
× 6 mm)