Kenwood DPX-4010 - Manual (Page 13)

— 13 —
Listen to tapes recorded using Dolby B NR.
Turning Dolby B Noise Reduction On/Off:
Press the B NR button to switch Dolby B NR on and off.
The B NR indicator lights up when it is turned on.
Using Dolby B Noise Reduction
Fast Forwarding Tapes:
Press the FM button.
Rewinding Tapes:
Press the AM button.
Canceling:
Press the 38 button.
Normal tape play will begin.
Fast Forwarding and Rewinding Cassette Tapes
• When the faceplate has been dropped open, it might interfere
with the shift lever or something else. If this happens, pay
attention to safety and move the shift lever or take an
appropriate action, then operate the unit.
• Do not apply excessive force to the open faceplate or place
objects on it. Doing so will cause damage or breakdown.
• Do not use the unit with the faceplate in the open condition.
Doing so will cause breakdown.
Remove a cassette from the unit when not listening to it for a
while. If you leave it in the unit too long, the tape may stick to
the tape head and cause the unit to malfunction.
NOTE
2CAUTION
Select type of tape being played.
Switching Tape Types:
Press the METAL (Metal) button to switch the metal tape
indicator on and off and to select the tape type.
Turn the MTL indicator off for normal tape (Type I) playback.
Turn the MTL indicator on for the following tape types:
CrO
2
(Type II) FeCr (Type III) Metal (Type IV)
Selecting the wrong tape type may cause sound quality to
suffer.
Switching Tape Types
Switching the Tape display :
Each time you press the DISP button, the display during tape
play switches as follows:
The tape counter is not exact, but only represents an
approximation of the elapsed time.
NOTE
Character
Clock
Play side/Tape counter
Tape counter display