Kenwood DPX-4010 - Manual (Page 23)

— 23 —
You can choose the equalizer from four settings whose sound
qualities are preset to match music or vehicle characteristics.
Switching the Preset Equalizer:
Press the EQ button.
"EQ mode" is displayed once the equalizer mode is entered.
Each time you press the EQ button, the preset equalizer
switches as follows;
Press the EQ button for at least one second to end the
equalizer mode.
If you make no button operation for 10 seconds, the equalizer
mode is automatically canceled.
NOTE
3
3 "Rock" 3 "Pops" 3 "Vocal" 3 "Heavy" 3 "Flat"
2
1
Preset Equalizer Selection
You can adjust the level of the equalizer effects.
Press the EQ button.
"EQ mode" is displayed once the equalizer mode is entered.
Each time you press the AM or FM button, the equalizer
effects switch as follows;
• This adjustment cannot be made when the Preset Equalizer
Selection is set to "Flat".
• The default setting is "MID".
Press the EQ button for at least one second to end the
equalizer mode.
NOTE
3
NOTE
3
2
3
2 "LOW" "MID" "HIGH"
2
1
Equalizer Level Adjusting
You can select the display to enjoy sounds with eyes.
Switching the Spectrum Analyzer Display:
Press the S.A button.
"SPEANA mode" is displayed once the analyzer mode is
entered.
Each time you press the S.A button, the analyzer display
switches as follows;
Press the S.A button for at least one second to end the
analyzer mode.
If you make no button operation for 10 seconds, the analyzer
mode is automatically canceled.
NOTE
3
▼
▼
▼
▼
▼
▼
▼
▼
▼
"Peak Hold"
▼
"SPEANA scan"
"Squall"
"Catcher"
"Radar"
"Falling Star"
"Music Scope"
"Level Meter"
"Rolling Bar"
"Stream"
The spectrum analyzer display switches in
sequence for 10 secconds each.
2
1
Spectrum Analyzer Display Selection
If you make no button operation for 10 seconds, the equalizer
mode is automatically canceled.