Switching display for tuner – Kenwood DPX-4010 User Manual

Page 11

— 11 —

You can change the display used when listening to the radio.

Changing the Display:

Each time you press the DISP button, the display changes as
follows:

Character

Station frequency

SNPS name (only when being preset)

Clock

Switching Display for Tuner

Continue steps 3 and 4 until all the characters are chosen for
the name.

You can enter up to 8 characters for each name.

Assigning Names
Press the NAME.S button.
The name of the station is stored in memory, and the Station
Name Preset mode ends.
Also, if you make no input for 10 seconds, the name will be
stored up to the point that you have entered, and the mode
ends.

• You can assign names to up to 30 FM/AM stations in all.

If you try to enter more than that, the station name stored the
earliest will be the first one erased.

• If you want to change the name of a station, first display the

name of the station (following steps 1 and 2 above), then
change the letter(s) that you want by following steps 3 and 4.

NOTE

Alphabet (upper case)/Numerals/Symbols:

A ~ Z 0~9 / + –

Alphabet (lower case)/Numerals/Symbols:

a ~ z 0~9 / + –