Kenwood DPX-4010 - Manual (Page 31)

— 31 —
Installation ■
Installation (for TOYOTA, NISSAN Car etc.)
When performing a check of the CD operation prior to installation,
place this unit in a hirizontal position and perform a loading/eject
of the CD.
2CAUTION
Install onto the car bracket using the supplied screws (M5
×
6
mm). The holes of the car bracket to use will differ depending on
the car model.
When a ground wire is
included in the wiring kit
(which is sold separately),
fasten the ground wire
with the binding screw
located on the rear panel
of this unit.
Accessory2
(M4
× 6 mm)
Accessory1
or Accessory0
(M5
× 6 mm)
Accessory3
(Only for NISSAN car)
Installation (for HONDA ACURA Car)
Assembly ■
Bottom
panel
(The application
position of
Accessory5 is at the
bottom panel)
Fit the projections on both sides of the
Accessories 6 and 7 into the slits on
the Accessory4.
Accessory4
Accessory0
(M5
×
6 mm)
Accessory7 (R)
Accessory6 (L)
Accessory0
(M5
× 6 mm)
You can choose from three installation types to fit your car.
Perform "Assembly" before installation.