Kenwood DPX-4010 - Manual (Page 25)

— 25 —
You can choose from three tuning modes: auto seek, preset
station seek, and manual. The "AUTO 1" indicator lights up
when auto seek tuning is selected, and the "AUTO 2" indicator
lights when preset station seek tuning is selected.
Display and setting:
"Auto1 Seek" : Auto seek tuning mode
"Auto2 Seek" : Preset station seek tuning mode
"Manual Seek" : Manual tuning mode
Selecting Tuning Mode
Switch the preout between the rear and non-fading. The
factory default is rear preout.
Display and setting:
"Preout Rear" : Rear preout
"Preout N-F" : Non-fading preout
Switching preout
The Display Mode sets the number of display colours used by
the Spectrum Analyser.
Display and setting:
"DISP MODE A" : The display can be set to use three colours:
white, light blue and blue.
"DISP MODE B" : The display can be set to use two colours:
white and blue.
Selecting Display Mode
You can adjust the Dimmer level of the unit when your car's
light switch has been turned on.
Display and setting:
"DIM STEP 1" – "DIM STEP 5"
This function is available when the dimmer wire is connected and
the light switch of your car is turned on.
NOTE
Dimmer Level Adjustment
This function produces a beep sound that accompanies button
operation. It can be switched on or off.
Display and setting:
"BEEP On" : Beep setting is on.
"BEEP Off" : Beep setting is off.
The beep sound is not output from the preout jacks.
NOTE
Touch Sensor Tone
Function items in Standby mode:
Function items in Tuner mode: