Presetting disc names (dnps) – Kenwood DPX-4010 User Manual

Page 21

— 21 —

as this, and the characters to be input are selected using the
procedure described below.
Press the DISC

or DISC

–

button to display the desired

character. Besides the alphabet (capital letters only) and
numbers, you can choose the following characters: /,

–

∗

=, <, >, [ and ].

Continue steps 3 and 4 until all the characters are chosen for
the name.

You can enter up to 8 characters for each name.

Press the NAME.S button.
The disc name is stored and the disc name preset mode is
canceled.
If you make no entry in a 10-second period, the name will be
stored with the characters input so far.

• The number of discs whose names can be stored will differ

depending on the disc changer that is connected. Please see
your disc changer manual for details.
Up to 10 CDs can be registered with this unit.

• Discs are identified by their total length and number of tracks. If

another disc happens to have the same specifications as one
that you have already stored a name for, the name will be
displayed for it, too.

• If you want to change the name of a disc, repeat steps 1 and 2

to display the name, and then repeat steps 3 and 4 to input the
changes.

• Pressing the reset button erases the disc names stored in this

unit, but does not erase names stored in a disc changer.

• Each source (CD,DISC-CH1,DISC-CH2) has its own memory in

which to store the disc names.
Discs that have been disc name preset with the CD player will
not have their disc name displayed when played on a CD
changer.

NOTE

Store the names of discs to be displayed when played.

Play the disc whose name you want to preset.

• This function is available only for the CD player of this unit and

disc changers that feature the Disc Name Preset function.

• This procedure is not to be used to store the disc and track

titles for MDs that you record.

• This function cannot be available during the clock display and

while using disc scan or magazine random play.

Press the NAME.S button for at least two seconds.
"Name Set" is displayed and the disc name preset mode is
entered.
The cursor blinks in the position where character input can be
made.

Press either the

4 or ¢ button to move the cursor to the

desired position.
The

4 button moves the cursor to the left, and the ¢

button to the right.

Each time the

38 button is pressed, the characters to be

entered change as listed below.
Press the DISC

or DISC

–

button to display the desired

character.
Characters that can be displayed are as follows.

The operation and characters that can be entered may change
as listed below, depending on the unit that is connected.
A press of the

38 button exits the disc name preset mode.

Operations can be followed again from Step 2 at a time such

NOTE

Alphabet (upper case)/Numerals/Symbols:

A ~ Z 0~9 / + –

Alphabet (lower case)/Numerals/Symbols:

a ~ z 0~9 / + –

NOTE

Presetting Disc Names (DNPS)