Kenwood KVC-1000 - Manual (Page 35)

English
35
The following indications are used to inform you that there is a problem with the connections of
the system.
BUS-E50: Two or more the KTC-1000R or A907 are connected.
BUS-W02: The No. switch of the connected disc changers is set to the same number (1 or 2) for both units.
] Set the No. switch of one disc changer to "1" and the other unit to "2" to enable proper use.
BUS-W08: Two or more monitors are connected to the BUS terminal.
The following messages are displayed when certain problems are occurring in your system.
Take the recommended actions.
Nothing has been recorded on the MD.
] The next MD will automatically be played.
BLANK
No disc magazine has been loaded in the changer. The disc magazine is not completely loaded.
] Load the disc magazine properly.
No CD in the unit.
] Insert the CD.
EJECT
No disc has been loaded in the disc magazine.
] Load a disc into the disc magazine.
The CD is quite dirty. The CD is upside-down. The CD is scratched a lot.
] Clean the CD and load it correctly.
E-04
No tracks are recorded on the MD, although it has a title.
] The next MD will automatically be played.
NO TRACK
The protective circuit in the unit activates when the temperature inside the automatic disc changer
exceeds 60°C (140°F), stopping all operation.
] Cool down the unit by opening the windows or turning on the air conditioner. As the temperature
falls below 60°C (140°F), the disc will start playing again.
HOLD
No disc has been loaded in the disc magazine.
] Load a disc into the disc magazine.
NO DISC
Something is wrong with the disc magazine. Or the unit is malfunctioning for some reason.
] Check the disc magazine. And then press the reset button on the unit. If the "E- 99" code does not
disappear, consult your nearest service center.
E-99