Kenwood KVC-1000 - Manual (Page 11)

3Mask Key
If you have transmitted the Mask Key's signal
once to the unit in advance, you will have to
transmit it once again if the unit has been
removed from the battery. This function helps
prevent theft.
When using the unit for the first time:
If this procedure is not carried out, the control panel of
the unit will re-open even with your vehicle's ignition
turned off.
Hold down the transmit button on the Mask Key
until the half transmit level indicator lights up in the
display. “System now checking for valid signal
code”will be displayed.
• Keep the Mask Key close to the signal sensor when
you transmit the Mask Key signal.
• If the Mask Key signal does not be received
correctly, the display will return to “Code rejected.
Please check MASK KEY”. In this case, repeat the
procedure in step 1.
Hold down the transmit button on the Mask Key
again until the full transmit level indicator lights up
in the display.
"Code APPROVED" will appear in the display, with
the Mask Key function turning on.
If you press the RESET button or remove the battery:
The first time you turn the unit on again, “The
system in now waiting for your MASK KEY signal.
Please input now.” will appear in the display,
indicating the setting mode has been entered. Repeat
steps 1 and 2 above, and transmit the signal.
You can start operating the unit again when "Code
APPROVED" appears in the display.
3Ending the Code Security Screen
Touch [ RTN ] to return to the setup menu screen.
2
NOTE
1
English
11
RTN C O D S E E C U R I T Y
T h e s y s e m i s n o w
g f o r y o u r
E Y s i g n a l .
i n p u t n o w .
n
K
e
i
s
t
K
a
i
S
e
a
A
l
w
M
P
t
Code Security Screen
Transmit button
Transmission part
RTN C O D S E E C U R I T Y
S y s t e m o w
n g f o r
s i g n a l c o d e .
i k d c i e l h a c v
n
RTN C O D S E E C U R I T Y
S y s t e m o w
n g f o r
s i g n a l c o d e .
i k d c i e l h a c v
n