Kenwood KVC-1000 - Manual (Page 33)

English
33
Connecting and Install Antenna Units
Connection of Antenna Unit ■
CAR DIVERSITY ANTENNA WITH BOOSTER CX-A330
ON
OFF BOOST
– +
Booster switch
Set this booster switch to
"OFF" if there is ghosting
of the on-screen image
due to electromagnetic
fields.
ON
OFF
To the monitor unit
Ignition cable (Red) ª12V Ignition key switch
Car fuse box
(Main fuse)
ACC
Ground cable (Black) · (To car chassis)
Battery
Incar antennas have a lower reception sensitivity than antennas intended for outside mounting. The picture may not
appear or may be disturbed if the signal in your area is weak.
2 CAUTION
Fuse(1A)
• Attach the antenna to the inner glass surface of the rear window using double-sided tape. Carefully check the installation
location as the tape can only be stuck on once.
• If the surface temperature of the glass of the rear window is low, warm it by turning on the power of the rear defogger.
A cold window glass surface will weaken the adhesive strength of the double-sided tape.
Also, if installation inside the cabin is performed on a day with high humidity or when it is raining, the high humidity level
will weaken the adhesive strength of the double-sided tape.
• Do not install the antenna in a location where it may obstruct the field of view during driving, such as on the windshield.
Check the location where the antenna is to be attached. Clean off any grease
or dirt from the installation location using the supplied glass cleaner, clean the
area with water and allow to dry.
Clean the glass thoroughly as failure to clean the glass can not only weaken
the adhesive strength of the double-sided tape, but may also cause it to come
loose.
Remove the protective strips from the antenna parts and the back of the
antenna unit.
Attach the double-sided tape of the antenna parts and the antenna unit to the
rear windshield glass. Attach the double-sided tape by firmly pressing down
from the top. Secure cables using the supplied clampers.
After attaching the antenna with the double-sided tape, allow it to sit
undisturbed for 24 hours. Take care not to apply force to the antenna or allow it
to get wet during this time.
Wire the antenna cable to the hideaway unit.
5
4
3
2
2 CAUTION
1
Antenna parts
Antenna unit
Accessory 8
Rear seat
Rear window
Bundle cables
with the
clamper bar
Installation for Antenna Unit ■