Setting surface controls, About the ceramic glass cooktop, About the radiant surface elements – Kenmore 790.4658 User Manual
Page 8
8
Setting Surface Controls
1. Place the pan on the surface element.
2. Push in and turn the surface element control knob to desired setting.
3. The surface signal light will glow when one or more elements are turned on. Always turn
the element off before removing the pan.
Setting
Type of Cooking
HI (MAX)
Start most foods, bring water to a boil, pan broiling.
5 (MED)
Maintain a slow boil, thicken sauces and gravies, steam vegetables.
2-4 (MED-LOW)
Keep food cooking, poach, stew.
LO (MIN)
Keep warm, melt, simmer.
*The suggested settings found in the chart above are based on cooking in medium thickness
aluminum pans with lids. Settings may vary when using other types of pans.
Do not place items such as salt and pepper shakers, spoon holders or
plastic wrappings on top of the cooktop when it is in use. These items could melt or
ignite. Potholders, towels or wood could catch fire if placed too close to the element.
Setting Surface Controls
Models with Coil Surface Elements
Models with Ceramic Glass Cooktop
About the Ceramic Glass Cooktop
The ceramic cooktop has radiant surface elements located below the surface of the
glass. The design of the ceramic cooktop outlines the area of the surface element
underneath. Make sure the diameter of the pan matches the diameter of the element
outline on the cooktop (See Figure 1).
Heat is transferred up through the surface of the cooktop to the cookware. Only flat-
bottom cookware should be used. The type and size of cookware, the number of surface
elements in use and their settings, are all factors that will affect the amount of heat that
will spread to areas beyond the surface elements. The areas surrounding the elements
may become hot enough to cause burns.
Figure 1
LEFT
FRONT
LEFT
REAR
ELEMENT ON
RIGHT
FRONT
RIGHT
REAR
ELEMENT ON
About the Radiant Surface Elements
The element temperature rises gradually and evenly. As the temperature
rises, the element will glow red. To maintain the selected setting, the element
will cycle on and off. The heating element retains enough heat to provide a
uniform and consistent heat during the off cycle. For efficient cooking, turn off
the element several minutes before cooking is complete. This will allow
residual heat to complete the cooking process.
Locations of the Radiant Surface Elements and Controls
Your range is equipped with radiant surface burners with different wattage
ratings. The ability to heat food quicker and in larger volumes increases as
the element wattage increases.
The radiant surface elements are located on the cooktop as follows:
- 2 smaller 6 inch radiant elements located at the right and left rear position;
- a dual 6 or 9 inch radiant element located at the right front position;
- a 9 inch radiant element located at the left front position;
NOTE: Please read detailed instructions for ceramic glass cooktop
cleaning in the General Care & Cleaning section and Before You Call
checklist section of this Use and Care Guide.
NOTE: Radiant elements have a limiter that allows the element to cycle on
and off, even at the HI setting. This helps to prevent damage to the ceramic
glass cooktop. Cycling at the HI setting is normal and can also occur if the
cookware is too small for the radiant element or if the cookware bottom is not
flat (Refer to page 10 for using correct cookware instructions with the cooktop).
Figure 2
NOTE: (White glass cooktops only) Due to
the high intensity of heat generated by the
surface elements, the glass surface will
turn green when the element is first turned
off. This phenomenon is normal and the
glass will come back to its original white
color after it has completely cooled down.
Note: The size and type of
utensil used, and the
amount and type of food
being cooked will influ-
ence the setting needed
for best cooking results.