General care & cleaning (cont’d), English, Storage drawer – Kenmore 790.4658 User Manual
Page 25: Changing oven light
ENGLISH
25
General Care & Cleaning (cont’d)
Storage Drawer
Use the storage drawer for storing cooking utensils. The drawer can de removed
to facilitate cleaning under the range. Use care when handling the drawer.
Removing and Replacing Storage Drawer
To remove the drawer:
1.
Pull empty drawer out to the roller guide stop.
2.
Tilt the drawer up and pull it out over the rollers.
To replace the drawer:
1. Insert the rear end of the drawer into the opening.
2. Fit the drawer end rollers onto the guide rails.
3. Push the drawer in until it stops, then lift to allow the rollers to clear the
roller guide stop, and push in.
Changing Oven Light
Be sure the oven is unplugged and all parts are COOL before replacing the oven light bulb. Do not turn the
oven light on during a self-cleaning cycle. High temperature will reduce lamp life.
On some models an interior oven light will turn on automatically when the oven is opened.
The oven light may be turned on when the door is closed by using the oven light switch located on the Electronic Oven
control.
The oven light bulb is covered with a glass shield held in place by a wire holder. THIS GLASS SHIELD MUST ALWAYS
BE IN PLACE WHEN THE OVEN IS IN USE.
To Replace the Light Bulb:
BE SURE OVEN IS COOL
1. Turn the power off at the main source.
2. Wear a leather-faced glove for protection against possible broken glass.
3. Replace bulb with a 40 Watt appliance bulb only.
4. Press wire holder to one side to release glass shield, change bulb and
be sure to replace glass shield.
Front Frame
Roller Guide
Roller
Storage
Drawer