Kenwood Z919 - Manual (Page 40)

English
— 40 —
Connecting Wires to Terminals
+
Р
+
Р
+
Р
+
Р
+
FRONT L
FRONT R
REAR L
REAR R
ANT
CONT
ILLUMI
P.CONT
10
M 4
REAR
NON
FADING
FRONT
EXT.CONT.
FM/AM antenna input
Rear right output (Red)
Rear left output (White)
Fuse (10A)
BUS terminals
Wiring harness
(Accessory1)
White/Black
Gray/Black
Green/Black
Purple/Black
White
Gray
Green
Purple
To front
left speaker
To front
right speaker
To rear
right speaker
To rear
left speaker
Ignition wire (Red)
Battery wire (Yellow)
Ground wire (Black) - (To car chassis)
Ignition key
switch
Car fuse
box
(Main
fuse)
ACC
Car fuse box
Battery
Front right output (Red)
Front left output (White)
Non-fading right output (Red)
Non-fading left output (White)
Power control wire
(Blue/White)
Motor antenna control wire
(Blue)
Dimmer control wire
(Orange)
When using the optional power amplifier,
connect to its power control terminal.
To car light control switch
Depending on what antenna you are using, connect
either to the control terminal of the motor antenna, or
to the power terminal for the booster amplifier of the
film-type antenna.
When only two speakers are being connected to
the system, connect the connectors either to both
the front output terminals or to both the rear output
terminals (do not mix front and rear). For example, if
you connect the + connector of the left speaker to
a front output terminal, do not connect the -
connector to a rear output terminal.
2CAUTION
If you connect the ignition wire (red) and the battery
wire (yellow) to the car chassis (ground), you may
cause a short circuit, that in turn may start a fire.
Always connect those wires to the power source
running through the fuse box.
2WARNING
If no connections are made, do not let the wire come out from the tab.
External amplifier control
wire
(Pink / Black)
To "EXT.AMP.CONT." terminal of the amplifier
having the external amp control function.
Z919