Kingston Technology Bay Networks 2000 - Manual (Page 57)

Changing Hardware Configurations 51
Replacing the Hard Disk Drive
The following steps describe Replacing the Hard Disk Drive.
1. Reattach the four screws securing the drive to the disk drive tray.
2. Put the disk drive tray back inside the chassis and slide it back over
the two standoff screws.
3. Replace the two front screws, which draws the disk drive tray to the
front of the chassis.
4. Tighten the two standoff screws.
5. Attach the DC power cable at the bottom to the hard drive.
6. Attach the hard drive ribbon cable. Make sure the hard drive cable is
correctly positioned to the right.
NOTE : When standing in front of the unit, the red line on the ribbon
cable that signifies Pin 1 is on the left (i.e., facing the center
of the unit).
7. Reattach the small ribbon cable to the diskette drive. Note that the
connector has a key at the center.
CAUTION : Make sure the diskette drive connector gets replaced over
both rows; otherwise you would damage the drive.