Kingston Technology Bay Networks 2000 - Manual (Page 51)

Changing Hardware Configurations 45
Installing Additional DIMMs
The following illustration shows you how to unlock a Dual Inline Memory
Module (DIMM), and remove or install a DIMM. Install DIMM in the next
available slot (i.e., if the DIMM # 1 slot is populated, then add the next
DIMM to the DIMM # 2 slot).
Figure 20
−
Installing Additional Memory
1. Power off the Switch.
2. Press down the locking levers on both sides of the DIMM.
3. Pull the DIMM up to remove it from the slot.
4. Place a new DIMM in the slot, making sure to properly position the
DIMM's alignment keys.
5. Pull up the locking levers on both sides of the DIMM, and snap in the
DIMM, as necessary.