Kingston Technology Bay Networks 2000 - Manual (Page 47)

41
Chapter 6
Changing Hardware Configurations
This chapter describes how to change existing hardware
configurations, including:
•
Installing LAN or WAN cards or adding memory.
•
Swapping out a power supply.
NOTE : Wear an antistatic band when handling electronic components for the
Switch to avoid damaging them.
WARNING: Turn off the Switch and unplug it before installing
LAN or WAN cards, system memory, or installing
a new power supply.
To install LAN and WAN cards you must first remove the Switch's top cover.
To replace a power supply or to use the Recovery Diskette, you must remove
the front bezel of the Switch.
Removing the Top Cover
The following illustration shows you how to remove the top cover from the
Switch. You must remove the cover to:
•
Install LAN or WAN cards.
•
Install additional memory.
•
Swap out a power supply.