Kingston Technology Bay Networks 2000 - Manual (Page 12)

Cabling the Switch 4
Connector Pinouts
The LAN connectors on the Switch are RJ-45 straight-through. The
following illustration shows the Switch connector's 10/100BASE-TX
pinouts.
Figure 2
−
10/100BASE-TX Pinouts
Optional WAN Interface
The WAN connectors are located on a PCI card that is installed in the switch.
Two DB26S connectors provide the signals needed to interface to V.35
equipment. Included in the accessory box are two cables that map the DB26S
signals to a standard V.35 connector. The cable pin-outs are shown below.
DB26
Pin Signal V.35
Pin
1 GND A
2 TDA P
3 RDA R
4 RTS C
5 CTS D
6 DSR E
7 GND B
8 DCD F
9 RCB X
11 ETB W
12 TCB AA
14 TDB S
15 TCA Y
16 RDB T
17 RCA V
20 DTR H
24 ETA U
Figure 3
−
DB26S-to-V.35 Cable Pinouts