Installing a new lamp, Warning ∆∆∆∆∆ getting started – Kodak 560 User Manual
Page 10
Read these instructions carefully before you remove the projector and
other components from the container.
1. Remove contents from shipping container and check against
the following list:
n Projector
n Power Cord
n Xenon Bulb (DO NOT REMOVE THE BULB FROM THE BOX
UNTIL DIRECTED TO DO SO)
n Tools
large and small Phillips screwdrivers
2. Place the projector on a flat, stable surface and adjust leveling feet
by turning. This revents the projector from rocking. Make sure the
projector is turned off and unplugged from the wall socket.
3. Remove the four (4) white thumbscrews attaching the lamp
house top cover. (Do not remove the small covering plate on the
lamp house cover if it is installed.)
Warning
∆∆∆∆∆
Getting Started
Installing a New Lamp
8
Wire Screw
Lamp Positive
Plane Mirror
Condenser Lens
Xenon Lamp
Ellipsoid Mirror
Lamp Adjusting Screws (3)