Krell Industries 7.1 User Manual

Page 40

Krell Home Theater Standard 7.1

System Configuration,

continued

Using this screen, you can enable loudspeakers that are in your sys-
tem in the left column and select loudspeaker characteristics in the
far right column.

FULL RANGE

sends 20Hz to 20KHz signals to the loudspeaker.

LIMITED

sends information from the crossover frequency (see below) to
20KHz to the loudspeaker. The frequencies below the crossover fre-
quency are sent to the subwoofer if present; otherwise, these low fre-
quencies are sent to the full range loudspeakers in the system.

SUB

Select

NORMAL

ENHANCED

to choose the amount of bass information

sent to the subwoofer.

NORMAL

sends the low frequencies from the

limited speakers and the .1 (or LFE) signal to the subwoofer.

ENHANCED

sends additional bass information from the left and right

loudspeakers to the subwoofer in addition to the low frequencies
from the limited loudspeakers and the .1 (or LFE) signal.

CRSOVR

Crossover selections are 120, 100, 80, 60, and 40 Hz. The standard
crossover setting is 80 Hz. Choose the crossover frequency appropri-
ate for your loudspeakers. The frequencies below the crossover
frequency are sent to the subwoofer if a subwoofer is present; other-
wise, these low frequencies are sent to the full range loudspeakers in
the system.

5.1 SURR

Select

SURROUND, BACK,

BOTH

to choose which loudspeakers in a

6.1 or 7.1 system receive surround information when playing a Dolby
Digital 5.1 or DTS 5.1 encoded software.

SURROUND

sends surround

channel information to your surround loudspeakers only.

BACK

sends

surround channel information to your back loudspeakers only.

BOTH

sends surround channel information to your surround and back loud-
speakers simultaneously.

After selecting the appropriate loudspeaker setups for your system,
press the previous key twice to return to the main menu.

Speaker Setup Screen,

continued

How To Navigate the Menu
and Make a Selection

1. Use the direction keys to scroll

from line to line.

2. Press enter to select a line.
3. Use the direction keys to scroll

through options within a line.

4. Press enter to select and set

an option.

5. Use the direction keys to scroll

to the next line.