Krell Industries 7.1 User Manual

Page 27

Connecting the Home Theater Standard 7.1
to Your System,

continued

Krell Home Theater Standard 7.1

The Home Theater Standard 7.1 is equipped with six coaxial digital
audio inputs (44) via RCA connectors and two digital EIAJ optical
inputs (43) via TosLink connectors. Connect the digital audio output
of your source components to the digital inputs on the Home Theater
Standard 7.1.

For sources that are equipped with both digital and analog outputs, the digi-
tal outputs should be connected for listening in the main zone; the analog
outputs should be connected for listening in zone 2 and for recording from
the main zone or zone 2.

1. The Home Theater Standard 7.1 will only operate correctly:

• When the video source signal (component, s-video, or compos-

ite) to the Home Theater Standard 7.1 and the video signal from
the Home Theater Standard 7.1 to the video monitor match,

and

• When the video device is configured for that same signal (com-

ponent, s-video, or composite) in the Home Theater Standard 7.1
configuration menu.

2. If you select the video signal that is the factory default for the

video device (for example: a component signal for the DVD), you
do not need to configure the video signal in the Home Theater
Standard 7.1 configuration menu. See Figure 4, for North
American operation, on page 25, and Figure 5, for overseas
operation, on page 26.

3. If you are not using the default video signal, you must use the

configuration menu in the Home Theater Standard 7.1 and
change the video signal for the video device.

4. You need the remote control and the on screen display (OSD) to

access the configuration menu.

5. In order for the OSD to be visible:

• Set your monitor to NTSC Interlaced for North American

operation,

• Set your monitor to PAL Interlaced or NTSC Interlaced for

overseas operation.

When your monitor is set to NTSC Progressive or PAL
Progressive, the OSD will not be visible.

6. The video device LED must be illuminated on the front panel

of the Home Theater Standard 7.1 in order for the OSD to be
visible.

Note

Step 3: Connect
Digital Sources

Please read
before continuing
on to Step 4