4 function codes, Using function codes, 4function codes – Kodak 9500 User Manual
Page 26
A-61092 September 1999
4-1
4
Function Codes
Using function
codes
There are a variety of functions available which may be used to
temporarily change operating parameters, and to obtain system
and accessory status information.
These functions are listed in the Function Code Summary later in this
chapter. Following are the procedures for using function codes:
1. Press
the
F key.
2. Press the numeric keys which correspond to the desired function
code.
3. Press
Enter.
If the function is used to enable or disable an operation (turn an option
on or off):
1. Press
1 to turn the option On, or 0 to turn the option Off.
2. Press
Enter.
If the function requires numeric input:
1. Press the numeric key(s) required.
2. Press
Enter.
If the function is used to increment or decrement a measurement or
setting:
•
Press the arrow keys to increment or decrement as follows:
−
Press
the
Up arrow to increment the measurement by
1 inch (25 mm) or one value, or
−
Press
the
Down arrow to decrement the measurement by
1 inch (25 mm) or one value, or
−
Press
the
Right arrow to increment the measurement by
1/8-inch (3 mm) or one value, or
−
Press
the
Left arrow to decrement the measurement by
1/8-inch (3 mm) or one value.
•
Press
Enter.
To cancel a function (before pressing Enter) or clear the status display
after executing a function code:
•
Press
C (Clear/Cancel).