Kodak 9500 - Manual (Page 106)

8-40 A-61092 September 1999
Enabling patch
reading Make sure patch reading is enabled before feeding documents.
•
Patch reading may be enabled or disabled at the mode level using
function code F50.
If you have enabled patch reading, but do not want to read a patch found
on the next document only, perform function code F54.
Enabling the patch
code confirmation
tone
The patch code confirmation tone may be used to signal that a patch has
been read.
•
If your machine is configured for no confirmation tones, then no
confirmation tones of any kind will be heard in any mode.
•
If your machine is configured to allow confirmation tones, then you
can disable (or enable) confirmation tones in any mode as desired.
•
If the machine confirmation tones and the patch code confirmation
tone are enabled during installation for the mode being used, you may
enable/disable the patch code confirmation tone during normal
operations by performing function code F53.
NOTE: In addition, a patch/bar code confirmation tone may be used
to signal that both a patch and a bar code and have been
detected. This confirmation tone may be enabled or disabled
by performing function code F62.
Cleaning the Patch
Reader Periodically wipe the sensor at the end of the Patch Reader with a dry, lint-
free cloth.
Sensor