Kodak 9500 - Manual (Page 12)

A-61092 September 1999 2-1
2 Getting Started
The following steps are necessary to prepare the scanner for operation.
Procedures on how to perform these steps are described in this
chapter.
1. Turn on the main power switch.
2. Turn on the side panel switch.
3. Select the language display.
4. Calibrate the scanner.
5. Adjust the feed and separator roller gap.
6. Adjust the feed shelf position.
7. Adjust the feed shelf side guides.
8. Adjust the exit hopper side guides and end stop.
9. Change the deflector (if required).
10. Prepare documents for scanning.
Turning on the
scanner Follow the steps below to turn on the power to the scanner.
1. Turn on the main power switch (located at the rear of the scanner).
NOTE: It is not necessary to turn off the main power switch during
normal daily operations.
2. Turn on the side panel switch.
Wait until the status display indicators are lit and an operating display
appears before you continue.
Selecting the
language display The scanner may have been configured at installation to allow use of a
second language in the status display. The language used (French,
German, Italian, Spanish, or other) is defined during installation. If
available, the alternate language display may be accessed using
function code F19.