Kenwood Z910DVD[R] - Manual (Page 64)

— 64 —
English
Installation
Removing the Unit ■
Lower the removal tool
toward the bottom, and
pull out the unit halfway
while pressing towards the
inside. 4
Pull the unit all the way out
with your hands, being
careful not to drop it. 5
Be careful to avoid injury from the catch pins on the removal tool.
2CAUTION
Catch facing up
Refer to the section “Removing the hard rubber frame (P. 63)”
and then remove the hard rubber frame.
Remove the screw (M4 ×8) on the back panel.
Insert the two removal tools deeply into the slots on each
side, as shown. 3
2
1
Accessory2 Removal tool
Screw (M4X8)
(commercially
available)
Accessory5
Screwing the Faceplate on the Unit ■
Never insert the provided screw (M2 × 3 mm) in any other
screw hole than the one specified. If you screw it in another
hole, it will contact and may cause damage to the mechanical
parts inside the unit.
2CAUTION
If you want to fasten the faceplate to the main unit so that it
does not fall off, screw in the provided screw (M2
× 3 mm) in
the hole shown below.
Installation for Amplifier unit ■
Use the tapping screw (ш4 Ч 16 mm) to secure the hideaway unit
to the audio board.
(ш4 Ч 16 mm) (Accessory 7)
Do not install the unit under the carpet. Otherwise heat build-up occurs
and the unit may be damaged.
2CAUTION
Z910DVD(K)_U.S 02.12.13 6:43 PM Page 64