Kenwood Z910DVD[R] - Manual (Page 63)

— 63 —
Removing the hard rubber frame ■
When the lower level is removed, remove the upper two
locations. 2
The frame can be removed from the top side in the same
manner.
NOTE
Catch
Lock
Engage the catch pins on the removal tool and remove the
two locks on the lower level.
Lower the frame and pull it forward as shown in the figure. 1
Accessory2 Removal tool
8 mm
MAX.
M5mm M5mm
8mm
MAX.
Installing in Japanese-Made Cars ■
T: Toyota cars
N: Nissan cars
T
N
N
T T/N
Accessory3...for Nissan car
Accessory4 ...for Toyota car
• During installation, do not use any screws except for those
provided. The use of different screws might result in damage
to the main unit.
• Damage may occur if a screwdriver or similar tool is used with
excessive force during the installations.
2CAUTION
Refer to the section “Removing the hard rubber frame” and
then remove the hard rubber frame.
Align the holes in the unit (two locations on each side) with
the vehicle mounting bracket and secure the unit with the
accessory screws. 2
1
3
4
Z910DVD(K)_U.S 02.12.13 6:43 PM Page 63