Speaker setup, Set up each feature, Exit audio setup – Kenwood KDV-412 User Manual
Page 41: Fine adjust the system q value to the speakers, Set to standby mode, Select "standby, Set to the speaker matching mode, Select a speaker, Exit the speaker matching mode, Press for # seconds

English 41
A
udio C
o
n
tr
o
l
3
Set up each feature
Q
AM
SETUP
AUD
VOL
ATT
MENU
SCAN
STOP
M/S
RDM
REP
F.SEL
M.RDM
DISP
PTY/C.S.
SW
AME
AUTO
FM
SCRL
SRC
The setting range of each item is as follows:
Feature
Setting range
HPF/HPR
THRU (Filter Off)/40/60/80/100/120/150/
180/220 (Hz)
LPF
50/60/80/100/120 (Hz)/THRU (Filter Off)
PHAS
REV (180˚)/NML (0˚)
V-OFF
-8 – 0
LOUD
OFF/ON
AVOUT
-15 – 0
2ZON
OFF/DVD/AUX
4
Exit audio setup
Q
AM
SETUP
AUD
VOL
ATT
MENU
SCAN
STOP
M/S
RDM
REP
F.SEL
M.RDM
DISP
PTY/C.S.
SW
AME
AUTO
FM
SCRL
SRC
• If a volume offset is set for each source with "V-OFF", the
volume will be nearly the same for all sources when the
source is changed.
• You can select "AUX" for "2ZON" when CA-C1AX/CA-
C2AX (optional accessory) is connected.
• When "2ZON" is ON ("DVD"/"AUX"), you can only set "V-
OFF" and "LOUD".
• When using the dual zone function, different sources can
be output from the front speakers (source of this unit)
and rear speakers (disc source sound of this unit).
• For "LPF" and "PHAS", the feature "SWPRE" needs to be
set to "SW" (subwoofer) in advance in the menu setup,
and the subwoofer output to ON. For details on how to
set up "SWPRE", refer to