Kenwood KDV-412 - Manual (Page 40)

40 KDV-412
Audio setup
Sets up volume offset, dual zone function, etc.
1 Start audio setup
Q AM SETUP AUD
VOL
ATT
MENU SCAN STOP M/S RDM REP F.SEL M.RDM DISP PTY/C.S.
SW
AME AUTO FM SCRL
SRC
2 Select features to set
Q AM SETUP AUD
VOL
ATT
MENU SCAN STOP M/S RDM REP F.SEL M.RDM DISP PTY/C.S. SW
AME AUTO FM SCRL
SRC
Each time the knob is pressed, the type
changes in the following order.
Feature Setting range
HPF Specifies the front high-pass filter cutoff
frequency.
HPR Specifies the rear high-pass filter cutoff
frequency.
LPF Specifies the low-pass filter cutoff frequency.
PHAS Specifies the subwoofer phase.
V-OFF Adjusts the volume difference between sources.
LOUD Corrects treble and bass when the volume is low.
AVOUT Specifies the output level of the AV OUT terminal.
2ZON Turns the dual zone function ON/OFF.
Sets up sound effects, such as equalizer and speaker settings.
Detailed audio control
The following features can be set up under audio
control.
Display Setting
"R-VOL" Adjusts the volume of the rear speakers.
(Adjustable range: 0 – 35)
"SW L" Adjusts the volume of the subwoofers.
(Adjustable range: -15 – +15)
"BAS L" Adjusts the bass volume.
"MID L" Adjusts the middle volume.
"TRE L" Adjusts the treble volume.
"BAL" Adjusts the volume balance between the left
and the right.
"FAD" Adjusts the volume balance between the front
and the rear.
• For the setup method, refer to
and others> (page 13).
• Bass, Middle, and Treble can be set up for each source.
• "R-VOL" can be adjusted when the dual zone function is
set to ON.
"SW L" and "FAD" cannot be adjusted if the dual zone
function is set to ON.
For further information on the dual zone function, refer
to (page 40).
• "SW L" can be adjusted if "SWPRE" is set to "SW" in the
menu setup while the subwoofer output is set to ON.
For details on how to set up "SWPRE", refer to
setup> (page 48), and for subwoofer output, refer to
(page 42).
• "SW L" cannot be adjusted if "SWPRE" is set to "AV".
Audio Control