Kyocera DP-3600 User Manual

Page 90

Chapter 2 Operating the Page Printer

2-22

8 — Fonts at startup (for each interface)

This shows the font automatically selected when the printer starts up (default font). It is possible to set

different fonts for the parallel interface and the serial interface. The figure on page 2-20 shows default

settings. The font is set to "1" (Courier bitmap font).

This also shows font information similar to the column below if an optional interface is installed.

9 — KIR test pattern

This is used when setting the printer's KIR 2 mode. For details, see page 2-58.

10 — User font list

Following the status page, font listings are output which show the fonts which have been downloaded

to the printer from the computer.