Kenwood DPX-302 - Manual (Page 27)

27
XD SERIES (En)
Operation
To pause recording
(Main unit only)
÷ Pressing the key pauses recording after leaving a non-
recorded space of about 4 seconds.
÷ If the key is pressed again in less than 4 seconds after it has
been pressed, recording resumes from that instant.
Lit
TAPE A/B REC/ARM
÷ This unit cannot record on a high-position (Type II) tape or metal
tape.
÷ Remove tape slack before loading.
÷ When recording is started, the tape is transported in the
direction selected in this step.
÷ Wind the tape to the position where recording is to be started.
Check the tape transport direction indicator. ∞
The input source component
to be recorded should be dis-
played.
÷ If a disc has already been loaded when the CD input is
selected, it will starts to play automatically. In this case,
press the stop (
7) key to stop it.
C 2 D 0 1 1 : 1
÷ Even if deck A is selected, it is automatically switched to deck
B at the start of recording.
÷ Recording stops automatically when the tape side(s) to be
recorded have been fully recorded.
÷ Press the stop (7) key of the cassette deck unit to stop recording.
Selection of reverse mode
1
Select the “Tape Options”.
2
Select the “Reverse Mode”.
3
Select desired mode.
MENU SELECT
SELECT
SELECT
1 “ ” ........ Recording stops after having recorded
one side of tape.
2 “ ” ...... Recording stops after having recorded
both sides of tape.
3 “ ” ..... Recording stops after having recorded
both sides of tape.
÷ When the “2” transport direction indicator is lit, recording
always stops after having recorded one side of tape.
When Recording from a CD
Beat cancel function
There may be cases in which beat noise interferes with
recording of AM (MW)/LW broadcasting.
Switch to "Beat Cancel" before recording the program
you want to record. Make a trial recording and then
record where the transmission noise is lowest.
Recording (Deck B only)
The unit is equipped with handy functions for recording
from a CD. For details, refer to page 29.
1 Start recording an AM broadcast.
2 Press the Tape A/B key.
3 Listen to the sound on the trial re-
cording and select the best sound.
1 “Beat Cansel on”
2 “Beat Cansel off”
TAPE A/B