Kodak 7 - Manual (Page 22)

A-62032 November 1996 B-3
Installation environment Select the proper environment for using the printer to obtain the
optimum service from your printer. It should NOT be placed in a
location:
— which is exposed to direct sunlight.
— which is in the direct air stream of a cooler, heater, or
ventilator.
— where the temperature and the humidity are extremely high or
low. The room temperature should be 10–35
°
C (50–95
°
F) and
humidity should be 15–85% RH.
— which does not have a stable, level floor.
— which could easily get wet.
— which has poor ventilation and where ammonia gas might be
generated.
— which is far from a power supply.
NOTE: Please contact your service representative when you need to
move the printer to another place.
Power source Before connecting the power cord of the printer to the outlet, check
the following items:
— Only connect to a dedicated electrical socket-outlet.
— Use the printer in a place which is near an electrical outlet
and where there is little voltage fluctuation. (The power
supply voltage should be specified voltage
±
10% for imaging
and +10% or -15% for feeding. The power supply frequency
should be specified
±
1 Hz.)
— Do not plug the power cord into a multi-socket extension
cord.
— At frequent intervals, check to see that the power plug is not
abnormally hot, that there are not any cracks or scrapes on
the cord, and that the power plug is fully inserted into the
socket.
— Be sure to use an outlet made for a 3-pin plug.