Kodak 3020 - Manual (Page 7)

24
. Connect your EKTAPRO Slide Projector
to the mains with the mains lead . (UK users
note: A suitable fused 13A plug must be
fitted. See instructions on cable!) .
Turn on the mains switch (34).
The projector is switched on and ready for
use. The red LED (18) is on; lamp and fan are
switched off. I.e. the projector stays in a
"silent" mode. With any strike on a key
(such as transport, standby, ..) lamp and fan
will be switched on.
Note:
If a problem on the slide change is
detected, the red LED (18) (operation
indicator) will start to blink and the
projector can no longer be operated
(see Trouble Shooting Guide, page 34).
Switching-on the projector
EKTAPRO Slide Projectors will be exported throughout the world to countries with
differing mains voltages. The projectors are already set during manufacture to a fixed
mains voltage.
Shipments to countries with 100 or 120 V mains will be equipped with a 4 A slow blow/
250 V fuse. A spare fuse for replacement is also supplied.
Shipments to countries with 220, 230 or 240 V mains will be equipped with a T 2A L/
250 V fuse. A spare fuse for replacement is also supplied.
Before you switch on your projector ensure that the voltage is correctly adjusted! An
incorrectly adjusted mains voltage can damage the projector! The voltage indicator
(30) must show your country´s actual mains voltage!
1.
Setting of a different operation voltage
WARNING
For safety, the mains lead must be unplugged!
Important:
Ensure that the 100 and 120 V setting uses a different fuse to the 220 -240 V setting.
See text above!
1.
Unlock the fuse link compartment (31) by using a screwdriver and pull
compartment out.
2.
Push the fuse link (32) into the compartment so -
3.
- that the applied voltage can be seen in the window (30) of the compartment.
.
Push the loaded compartment (with mounting underneath) firmly into the
projector opening provided.
Check voltage setting
80
140
10
Tray setting
Round trays for both 80 slides and 140
slides can be used. The tray setting switch
(10) is set in the factory to accomodate the
80 tray. By using a small screwdriver, the
switch can be brought into the 140 position.
Caution
If the projector is not properly adjusted,
there will be transport problems!
You can only set the EKTAPRO 3020
before you switch on the projector!
Switching- on the
projector
2.
3.