Operation – Kodak 3020 User Manual

Page 10

Operation

EKTAPRO 5020 and

9020 Projector: Focusing

with the autofocus

Slide positioning

Press lightly the slide forward button (1).

The first slide will be moved into the slide

gate and will be projected.

Switch the autofocus (7) on

(Push button in).

Focusing

a) with KODAK EKTAPRO lenses or other

gear rack lenses:

- by turning the focusing knob (11)

b) with spiral lenses:

- by turning the lens by hand

Override feature

You can, however, re-adjust the focus at

any time using the focus buttons (2). The

autofocus is re-activated with the next slide

change.

Manual refocusing during projection is no

longer necessary as the built-in autofocus

device will automatically give the best def-

inition.

However, before you start, the first slide

has to be manually focused by turning the

knob for gear rack lenses (11) or by turning

the spiral lens (the lens mount should be

about in middle position) :

I. Using the buttons on the projector or

remote control*

Single Movement:

Press button (1)

forwards
backwards

Quick search and zero positioning:

To transport the tray quickly in either direc-

tion, press and hold down the slide change
button-backwards (1) [ ] until the posi-
tion wanted is reached. The tray will, how-

ever, automatically stop at 0 and will remain

in this position. If you want to repeat the

search run, press the slide change button-

backwards again.

Please note

Your EKTAPRO Slide Projector can sense

when there is a slide in the gate. Only then

will the shutter open and the lamp achieve

its optimum brightness.

In exceptional case the feature can also be

switched off with the IR Remote Control

(does not apply for the EKTAPRO 3020).

To do this, enter the figures 555 and con-

firm with "*".

*There are three different remote controls avail-
able as accessories to your EKTAPRO Slide Pro-
jector. (Description of the most important fea-
tures under Accessories page 35):

II. Using the built-in interval timer (EKT-

APRO 5020 and 9020 Projectors)

The built-in timer (6) enables the projector

to automatically transport your slides.

Eleven time settings can be made:

Marked time settings:

1; 2; 3; 4; 5; 10; 30; 60 sec

Unmarked interim time settings:

8 sec

(timer position between 5 and 10 sec)

20 sec

(timer position between 10 and 30 sec)

45 sec

(timer position between 30 and 60 sec)

Slide changing

Setting the timer:

Turn the timer clockwise, to the right, until

the time required agrees with the indicator

on the projector. The timer is now activated

and the first picture will be projected after

expiration of the set time interval.

Switching the timer off:

Turn the timer to the OFF position.

Note: The slide transport button can be

pressed at any time to project the next

slide independently of the timer setting .

The preset time of the timer will not be

interrupted.