Important safety precautions – Kodak 3020 User Manual

Page 5

Important Safety Precautions

When using your equipment, basic safety precautions should

always be followed, including the following:

1. Read and understand all instructions before using.

2. Always use the correct voltage, as described on page 24.

Incorrect voltage can lead to malfunctions in the projector.

3. Close supervision is necessary when any appliance is used by

or near children, or others who may not understand the need for

the following precautions. Do not leave the projector unattend-

ed while in use.

4. Care must be taken as burns can occur from touching hot

parts. For lamp replacement let the module cool down before

touching the lamp and the surrounding area. Do not place the

lampmodule on heat sensitive surfaces (s. p. 32).

5. Do not operate projector with a damaged cord or if the

projector has been dropped or damaged - until it has been

examined by a qualified service technician.

6. Position the cord so that it will not be tripped over, pulled, or

placed in contact with hot surfaces.

7. If an extension cord is necessary, a cord with a current rating

at least equal to that of the projector should be used. Cords rated

for less amperage than the projector may overheat.

8. Always unplug the projector from the mains before cleaning

and servicing (e.g. lamp replacement) and when not in use. Never

pull cord to plug from outlet. Grasp plug and pull to disconnect.

9. Let the projector cool completely before putting away.

10. To reduce the risk of electric shock, do not immerse this

projector in water or other liquids.

11. To reduce the risk of electric shock, do not disassemble this

projector, but take it to a qualified service technican if service

or repair work is required. Incorrect reassembly can cause an

electric shock when the projector is used subsequently.

12. The use of an accessory attachment not recommended by the

manufacturer may cause a risk of fire, electric shock, or injury

to persons. Only devices with safety-low voltage (SELV) are

allowed to be connected.

13. Connect this projector to a grounded outlet.

14. Keep air inlet (5) and air outlet (19) free from obstruction.

AVE

THESE

INSTRUCTIONS